Step by Step Guide to Install a Water Softener

BDS Engineering is world’s leading Water Pump manufacturer and supplier of supreme quality water solutions. BDS Engineering Water Softener: We have been in the industry for over a decade specialized Water Softener manufacturer.


You must focus on learning how to install a water softener. You must have spent a lot of time and money purchasing a water softener from the market. In order to make sure that the device works well and delivers you desired results, it is important to install it in the right manner.

Most of the water softeners available on the market are available with special instruction for installation. These instructions are very necessary to install softener the right way. Paying attention to these softeners is very important. Understand that every softener is has unique specifications. It is vital to have good knowledge about this. Make sure that you know about these specifications in detail to be able to install softener in the best possible manner.

Here are some steps to follow when installing a water softener:

Step 1: Location
It is important to choose the location for water softener carefully. Choose a dry are if you plan to keep the tank indoors. The area should free of fluctuation. When using two tank water softeners, make sure that two are joined closely. Indoor tanks should be installed at a place away from direct sunlight. A special jacket can also be used to protect the tank from sunlight.

Step 2: Electricity Outlet and Drain
The electricity outlet location is very important for installing water softener. It should be approximately fifty feet from the unit. Make sure that you have a drain near the unit. This should be around one and a half inches in diameter. Use tubing to provide extension to drain that is out of the way. The tubing should be flexible.

Step 3: Install Media
Install media in softener tank. The tank size will help you determine the exact way of media installation. Follow the direction given for media installation correctly to benefit from apt installation.

Step 4: Brine Tank
Now it is time to use brine tubing to join control valve of water softener to the brine tank. Once the tube is in place, connect the brine tank. Attach tubing from brine tank. Run the tubing into the drain.

Step 5: Program Softener Control
It is important to program control that softens water in the right manner.

Step 6: Backwash Cycle
You must run backwash cycle. This is imperative to investigate for all kinds of leaks. Look for loose fittings and tighten them at once.

Step 7: Watch for Proper Functioning
The last step is to see that everything is running in a proper cycle. In case, the water softener is working well, the installation is successful.

Following all the steps mentioned above will help you get install your water softener in the right manner. Successful installation will help you enjoy maximum benefits of water softener. These instructions are general. Hence, you should combine these with directions mentioned in the user manual. All the best!